Placing Documents

FAQ ID: 8202679500

Release date: 15 September 2015

Back to FAQ List

Solution

Place documents on the platen glass or in the feeder. Use the platen glass when scanning thick or bound documents such as books. You can load two or more sheets of documents in the feeder so that they can be scanned continuously.


IMPORTANT
Use documents that are completely dry
  • When placing documents, make sure that any glue, ink, or correction fluid on the documents has completely dried.

To avoid paper jams
  • Do not place the following types of documents in the feeder as this may cause paper jams:

- Wrinkled or creased paper
- Carbon paper
- Curled or rolled paper
- Coated paper
- Torn paper
- Onion skin or thin paper
- Stapled or clipped documents
- Paper printed by a thermal transfer printer
- Transparencies


NOTE
To scan documents more accurately
  • Documents placed in the feeder are scanned while being fed into the machine. On the other hand, documents placed on the platen glass remain in a fixed position while they are scanned. To ensure more accurate scanning results, placing documents on the platen glass is recommended.

To scan tracing paper or transparencies
  • To scan transparent documents (for example, tracing paper or transparencies), place them on the platen glass.

Placing Documents on the Platen Glass

1. Open the feeder.

2. Place the document face down on the platen glass.
  • Align the corner of the document with the top-left corner of the platen glass.



  • To scan transparent documents (for example, tracing paper or transparencies), cover them with plain white paper.

3. Gently close the feeder.
  • The machine is ready to scan the document.
  • When scanning is complete, remove the document from the platen glass.

Placing Documents in the Feeder

1. Spread the document guides apart.
  • Slide the document guides outward until they are slightly farther apart than the actual document width.


  • Pull out the tray extension when loading large documents to prevent them from drooping over the edge of the feeder.


2. Fan the document stack and align the edges.
  • Fan the document stack in small batches, and align the edges by lightly tapping the stack on a flat surface a few times.


3. Place the document(s) face up in the feeder.
  • Make sure that the document stack does not exceed the load limit lines ().



  • Do not load documents of various sizes at the same time.
  • Up to 50 sheets can be loaded at a time. If 51 or more sheets are loaded, scanning may stop or a paper jam may occur.

4. Align the document guides against the edges of the document.
  • Slide the document guides inward until they are aligned securely against the edges of the document.


  • The machine is ready to scan the document.


Align the document guides securely against the edges of the document
  • Document guides that are too loose or too tight can cause misfeeds or paper jam.

While documents are being scanned
  • Do not add or remove documents.

When scanning is complete
  • Remove the scanned documents from beneath the feeder to prevent paper jams.

Applicable Models

  • i-SENSYS MF623Cn
  • i-SENSYS MF628Cw
  • i-SENSYS MF724Cdw
  • i-SENSYS MF728Cdw
  • i-SENSYS MF729Cx

Did this article answer your question?